Genuino MKR1000

Description

Overview
Genuino MKR1000 has been designed to offer a practical and cost effective solution for makers seeking to add WiFi connectivity to their projects with minimal previous experience in networking. The design includes a Li-Po charging circuit that allows the Genuino MKR1000 to run on battery power or external 5V, charging the Li-Po battery while running on external power. Switching from one source to the other is done automatically.

Technology
MKR1000 has a good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power WiFi with a Cryptochip for secure communication, and the ease of use of the Genuino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor. The board will be shipped with male strip header not mounted so you can adapt the board to your project by easily soldering them.

Important note
Unlike most Genuino boards, the MKR1000 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting. Li-Po batteries are charged at 4,2V with a current that is usually half of the nominal capacity (C/2).

For Genuino MKR1000 we use a specialized chip that has a preset charging current of 350mAh. This means that the MINIMUM capacity of the Li-Po battery shall be 700 mAh. Smaller cells will be damaged by this current and may overheat, develop internal gasses and explode, setting on fire the surroundings. We strongly recommend that you select a Li-Po battery of at least 700mAh capacity. A bigger cell will take more time to charge, but won’t be harmed or overheated. The chip is programmed with 4 hours of charging time, then it goes into automatic sleep mode. This will limit the amount of charge to max 1400 mAh per charging round.

Genuino MKR1000 and Arduino MKR1000 share the same components, characteristics and quality of manufacturing. They are actually the same board under a different brand. Depending on the area of the world where you live you’ll be able to purchase an Arduino MKR1000 or a Genuino MKR1000. Learn more.

The board will be shipped with male strip header not mounted so you can adapt the board to your project by easily soldering them.

Documentation
The Genuino MKR1000 is open-source hardware! These are the relevant files:
Schematics – Reference Design

If you want more information about programming the MKR1000 or how to interface hardware with it, please go to the Product Page. MKR1000 is programmed, as all the other Genuino boards with the Software (IDE) that you can download for free, with the addition of the Intel Curie core to download with Board Manager. To find inspiration for what you can do with the MKR1000, please visit the Genuino.cc Tutorials Page or take part in the community the lively discussions on the Forum.

 

Technical specifications

Microcontroller	SAMD21 Cortex-M0+
Operating Voltage	3.3 V
Input Voltage (recommended)	5 V
Digital I/O Pins	8
PWM Digital I/O Pins	4
Analog Input Pins	6
Analog Output Pins	1
Flash Memory	256 Kb
SRAM	32 Kb
Clock Speed	48MHz